Next, run the coaxial cable from the output port of the preamplifier to the power inserter TO AMP port. This will help keep water out of the amplifier housing. Leave enough slack in the transmission line to form a drain loop.
After the preamplifier is attached to the antenna or mast, run a length of coaxial cable from the antenna output connector to the input connector on the preamplifier. Preamplifier units come with the necessary hardware for easy mounting on the antenna mast. Preamplifiers mounted farther from the antenna usually amplify or magnify the interference along with the good signals. The preamplifier is best located as close as possible to the antenna, because the weak received signal must be amplified before it is attenuated by the coaxial cable and splitter. Power is supplied to the preamplifier unit through the coaxial cable. The power supply unit is mounted indoors. The preamplifier itself is mounted on the antenna boom or on the mast as close to the antenna as possible.
#Channel master signal booster tv
However, for multiple tv outlet installations and long cable runs a distribution amplifier is recommended to ensure that signal levels to each outlet are maintained at high enough levels to prevent drop out of the TV signals.Ī preamplifier consists of two pieces, the preamplifier itself and a power supply. In Yellow, Green, Light Green and some Red zone signal levels are usually strong enough at the antenna that a preamplifier may not be required. In some instances, it may be necessary to use both a preamplifier at the antenna and a distribution amplifier inside the home, but in most installations, there is no advantage to using both at the same time. If the signal levels are already bad at the input to the amplifier, they will not be improved by amplifying them. The reason for this is to ensure the amplifier is receiving sufficient signal levels. For Blue and especially Purple zone channels, or installations with very long cable runs and a high number of TV outlets, the Amplify Adjustable Gain Preamplifier (CM-7777HD) on the high gain setting may be the better choice.įor Red, Blue and Purple zone channels it is preferred to use a preamplifier at the antenna instead of a distribution/drop amplifier in the home. In most cases when the channels you are trying to view are in the Red zone, the Amplify Adjustable Gain Preamplifier (CM-7777HD) on the low gain setting should have sufficient gain, even when feeding up to four TV outlets, as long as the coaxial cable lengths are not excessively long. The Amplify Adjustable Gain Preamplifier (CM-7777HD) has a switchable 17-30dB adjustable gain setting. The Titan 2 High Gain Preamplifier (CM-7777v3) has 30dB of gain. The Titan 2 Medium Gain Preamplifier (CM-7778v3) has 16dB of gain. Preamp's Cannot be used with Amplified Antennas.Ĭhannel Master provides three preamp's with different amounts of gain.
Since the splitter used to connect multiple TV outlets in the home causes signal loss, a preamplifier at the antenna can help overcome these losses by increasing the signal levels coming from your antenna. One more situation that may benefit from use of a preamplifier is when multiple TV outlets are being fed from the same antenna. If there is 50 feet or more of cable between the antenna and TV set, a preamplifier may provide an improvement.
If the station/s you want to receive are in the Red or Grey you most likely will see an improvement in signal strength by installing a preamplifier.Īnother possible need for a preamplifier will be on installations with long coaxial cable runs from the antenna to the TV. One good way to determine if a preamplifier is needed it to enter your address into the Antenna Selection tool and review the listing of available channels at your location. Since this is not usually available for most home installations, determining the correct preamplifier can be challenging. The only sure way to determine if a preamplifier is needed is to measure the received signal levels with a field strength meter. In areas close to TV transmitters, a preamplifier is usually not needed and can actually cause problems as it may cause the signal levels to be too high. In areas distant from TV transmitters, overcoming this loss is necessary since the signals can be weak. A mast or antenna-mounted preamplifier is used primarily to overcome the loss in the coaxial cable between the antenna and the TV.
0 kommentar(er)
